Wednesday, September 14, 2011

What size battery cables on a 1992 Ford Explorer?

I have a 1992 Ford Explorer 4WD Eddie Bauer edition. I need to replace the battery cables. I went to buy some and there were a lot of different lengths. What size do I need? Is this a hard thing to replace?|||Red positive to the starter can fight.go to a automotive parts supplier ,Car-quest/Napa.


They will place in your hand just the ones you need for your ford.


"Not autozone/checker"don't forget the anti-corrision rings for the post and battery post sealer spray,fords tend to be bad about corrision.And the black ground also has a small wire grounded to the fender on this one.I think,disconnect black first reconnect last always.


make sure starter lead is not touching/rubbing sharp or hot parts.YOU CAN DO IT !!!|||They should be able to tell you what size you need at an autoparts store.It might be hard for you if you havent done it before.Also sometimes the starter has to be unbolted in some applications.If you havent worked on cars or done this before I wouldnt recommend you do this yourself.|||You can try the dealer for the exact cables for your vehicle, if they are not obsolete and are still available, no modifications required. But if shopping for aftermarket cables, longer may be better. You can always tie the extra cable up out of the way. If you start with a cable that is too short, you can't make it any longer. You want to make sure that the cables are not touching any hot engine parts, or crossing any sensitive wiring harnesses where electromagnetic fields could screw with electronic components. It may be better to let the local repair shop replace them for you.|||Size 12.5 mens.

No comments:

Post a Comment